S-421 Terminator Wedge Socket

S421 Wedge Socket.jpg
  • Wedge sockets have an efficiency rating of 80% based off the catalog strength of the wire rope.

  • Meets or exceeds ALL requirements of ASME B30.26 including identification, ductility, design factor, proof load, and temperature requirements.

  • Basket is cast steel and individually magnetic particle tested.

  • The pin diameter and jaw opening allow this socket to be used in conjunction with closed swaged and spelter sockets.

  • The wedge design allows the dead end of the wire rope to be more secured thus greatly reduces the loss of the wedge.

  • The design of the wedge eliminates the need for a small piece of wire rope.

  • Incorporates Crosby's patented QUIC-CHECK® "Go" and "No-Go" feature into the wedge.

  • The proper wire rope diameter is determined by:

  1. The wire rope should pass through the "GO" hole in the wedge.​

  2. The wire rope should NOT pass through the "No-Go" hole in the wedge.

  • Utilizes the standard Crosby Red-U-Bolt® wire rope clip (G450).​

  • Available in sizes from 3/8" to 1-1/4" (9mm to 32mm).

Terminator Wedge Socket Drawing.png
Terminator Wedge Socket Specs.png