HS-600 Hand Swager

• 5 cavity tool sizes 1/16", 3/32", 1/8", 5/32" and 3/16".

• swages aluminum and copper sleeves and stops.

• NOT for swaging stainless steel.

• complete with a built in cutter.

• overall length 25-1/2inches

• weighs 5.5lbs

• comes with a "no-go" gauge 

HS-600

P-25-02 Hand Swager

• swages only 1/16" aluminum and copper sleeves and stops.

• NOT for swaging stainless steel.

• ideal for swaging in tight spots due to its shorter length.

• overall length 8 inches

• weighs 1lb

• Made in USA

P-25-02

22-ST9 Hand Swager

• swages 1/32", 3/64", 1/16" aluminum and copper sleeves and stops.

• NOT for swaging stainless steel.

• has built-in cutter

• ideal for swaging in tight spots due to its shorter length.

• overall length 9 inches

• weighs 1lb

• Made in Japan.

22-ST9

64-CGMP Hand Swager

• swages 1/16", 3/32", 1/8", 5/32" aluminum and copper sleeves & stops.

• NOT for swaging stainless steel.

• made with heat treated, hardened drop-forged alloy steel.

• comes complete with a gauge, hex key, and an instruction sheet on how to properly use the tool.

• Made in USA.

64-CGMP

WARNING: The swaging of compression fittings directly over plastic coated wire rope will result in severely reduced holding power and is not permitted in applications where human safety, lifting or full wire strength is involved.  A sufficient length of the plastic jacket should be removed before swaging the proper size fitting directly over the bare wire rope.